Home
Quizzes
2024 International Building Code (IBC)
Chapter 21 Masonry

Quiz: 2024 International Building Code (IBC) Chapter 21 Masonry

Free Preview

5 of 50 questions

Free Preview: You're viewing a limited version with 5 questions. to access all chapters, including 50 questions for this chapter, detailed explanations, and progress tracking!

1. According to Section 2101.2, which of the following is NOT one of the primary design standards masonry must comply with in addition to the IBC requirements?

TMS 402
TMS 403
TMS 404
TMS 602

2. What is the requirement for the reuse of second-hand masonry units?

They must be cleaned of mortar and conform to the requirements of new units.
They can be used for non-structural applications only.
They must be certified by a structural engineer regardless of condition.
They are prohibited in Seismic Design Categories D, E, and F.

3. For a scratchcoat on a wall for ceramic tile installation, what is the required mortar composition according to Table 2103.2.3?

1 cement; 1/2 hydrated lime; 5 damp sand
1 cement; 1/5 hydrated lime; 4 dry or 5 damp sand
1 cement; 1/10 hydrated lime; 5 dry sand
1 cement; 1 hydrated lime; 7 damp sand

4. How many tension and bending tests must be performed on specimens of reinforcement from each shipment and grade proposed for use?

One tension and one bending test
Two tension and two bending tests
Three tension and three bending tests
Five tension and five bending tests

5. Where are molded cornices required to have their center of gravity located if structural support is not provided to resist overturning?

Within the outer one-third of the supporting wall
Within the middle one-half of the supporting wall
Within the middle one-third of the supporting wall
Within the inner one-third of the supporting wall

45 More Questions Available

Buy full access to 2024 International Building Code (IBC), including 50 questions for this chapter

Privacy Policy
Terms of Service
Refund Policy